Timex W-184 manual HANDS-FREE Settings, Watch Settings

HANDS-FREE SETTINGS

Hands-free features operate in conjunction with the GPS-3D Sensor. They automate chronograph features, freeing you to focus on your workout instead of operating your Watch.

Configure the following hands-free settings:

ϖAuto Split: This feature enables the chronograph to automatically take splits based on intervals (when you set intervals in Timer Mode), or by a distance, altitude, or a time you determine. For instance, you can configure the Watch to take a split every mile and then you can compare data for each mile in Lap Data Mode after you complete your activity.

ϖAuto Start: This feature enables the chronograph to start when you start moving. It may take a few seconds for the GPS- 3D Sensor to detect your movement, causing a slight delay in start time.

ϖAuto Stop: This feature enables the chronograph to stop when you stop moving. It may take a few seconds for the GPS-3D Sensor to detect that you have stopped moving, causing a slight delay in stop time.

NOTE: Even when enabled, you can still start and stop the chronograph manually and take manual splits without affecting the hands-free operation.

ϖSync Timer & Chrono: This feature allows you to set the timer and the chronograph to start and stop simultaneously so you can record chronograph data when you use the timer.

You must turn the Sync Timer & Chrono setting off if you want the timer to switch to the Chronograph, Finish, or Vertical Mode at the end of a countdown in Timer Mode.

WATCH SETTINGS

Configure the following Watch settings:

ϖNight Mode¨ feature: When enabled, the INDIGLO¨ night- light turns on when you press any button. This feature disables itself after eight hours.

ϖHourly Chime: When enabled, the Watch will chime at the top of every hour.

ϖButton Beep: When enabled, the Watch will emit a beep when you press any button.

ϖMode Hiding: You can choose to show, hide, or disable the

following modes: Vertical, Finish, Lap Data, Summary, Timer, Navigate, Waypoints, or Alarm. For example, if you hide Navigate Mode, you will not see any information from this mode unless you are using the GPS-3D Sensor. If you disable Navigate Mode it will not show up at all until you enable it again from Configure Mode.

66 67