If you choose to replace the battery yourself, carefully follow the steps below:
1.Place the Watch
2.Separate both halves of the Watch band using a small flat screwdriver.
NOTE: You must install the back of the Watch (caseback) in the same direction you removed it or the buzzer element will not function after reassembly.
3.Using a 00
WARNING: ALWAYS KEEP THE WATCH FACE DOWN ON YOUR WORK SURFACE. IF YOU TURN THE WATCH OVER TO REMOVE THE SCREWS OR CASEBACK YOU MAY LOSE THE SMALL ELECTRICAL CONNECTORS INSIDE THE WATCH.
4.Carefully open the battery clamp and remove the battery.
5.Place a new CR2430 cell in the battery compartment, making sure the side with the Ò+Ó marking faces you.
6.Reattach the battery clamp.
70
7.Replace the caseback, making sure the black gasket sits firmly in the case groove and the caseback properly aligns with the Watch to ensure the buzzer will line up with the internal connections (see note after Step 2).
8.Carefully reattach the straps so that the shorter piece with the buckle attaches to the upper set of lugs.
INDIGLO¨ night-light
Patented (U.S. Patent Numbers 4,527,096 and 4,775,964) electroluminescent technology used in the INDIGLO
Water resistance
Your Watch withstands water pressure up to 86 psi (equals immersion to 164 feet or 50 meters below sea level). This
WARNING: TO MAINTAIN WATER RESISTANCE, DO NOT PRESS ANY BUTTONS WHILE UNDER WATER.
While your Watch will resist water, you should not use this Watch for diving, as it is not a diverÕs Watch and you should rinse your Watch with fresh water after exposure to salt water.
NOTE: THIS WATCH WILL NOT DISPLAY S+D OR HEART RATE DATA WHEN OPERATED UNDER WATER.
71
