Toshiba 850, 720 manual Inserter mode optional, Available paper size and type for the Inserter Unit

Inserter mode (optional)

When you want to staple or punch holes on the paper without going through any copying operation, place sheets on the Inserter Unit (optional).

Also, when you want to insert blank sheets of paper at specified pages, place sheets on the Inserter Unit. ( P.167 “18.INSERTER”)

•Be sure to place the same size of sheets of paper on the Inserter Unit and align them.

•If the paper is fed from more than one paper source, such as the drawer, External Large Capacity Feeder, bypass tray or Inserter Unit, set all sheets of paper in one size in the same direction.

Available paper size and type for the Inserter Unit

Paper size	LD, LG, LT, LT-R, COMP
Media type	Plain paper (17 - 20 lb. Bond)
	Thick paper (21 lb. Bond - 140 lb. Index)
	Recycled paper
	Special paper (e.g. OHP film, color paper)
	(Contact a Toshiba-product distributor for details of the special paper available.)
Maximum number	17 - 20 lb. Bond: 100 sheets
of sheets can be set	21 lb. Bond - 140 lb. Index: Less than 0.47" in paper height (less than 0.28" in case
	of special paper)

•Note that some types of paper may not be applicable for the Inserter Unit due to their paper qualities, even if you are using the paper listed above.

•The use of the Inserter Unit has some restrictions on stapling and saddle stitching respectively.

( P.89 “Maximum number of sheets for stapling”, P.92 “Available conditions for saddle stitching”)

Setting paper on the Inserter Unit

1 Place paper on the Inserter Unit and adjust the side guides to the width of the paper.

• Place the paper with its face up.

• Be sure that the top and bottom of the paper to be inserted are the same as those of originals.

•Be sure that the height of the paper placed on the Inserter Unit does not exceed the indicator on the side guide.

•When you place large-sized paper on the Inserter Unit, widen the tray as shown in the illustration on the right.

3

95