TP-Link TL-WR702N manual Repeater Mode

TL-WR702N

150Mbps Wireless N Nano Router

Figure 2-2 Hardware Installation of the TL-WR702N in Router Mode

1.Connect the WAN port of TL-WR702N to the LAN Port on the DSL/Cable Modem.

2.Connect the WAN port on the DSL/Cable Modem to the wired Internet.

3.Plug the power plug of TL-WR702N in electrical wall socket.

4.Power on the DSL/Cable Modem, PC(s) and notebook(s).

2.3.3Repeater Mode

TL-WR702N is used to extend the range of wireless signal of the existing AP or wireless router.

On this mode, the only wired port works as LAN. Computer could connect to the device by either wired or wireless way. The SSID of TL-WR702N should be the same as that of the device you repeat.

Figure 2-3 Hardware Installation of the TL-WR702N in Repeater Mode

1.Plug the power plug of TL-WR702N in electrical wall socket.

2.Power on the notebook(s).

- 7 -