TP-Link TL-WR702N manual 2 LAN, MAC Clone

TL-WR702N

150Mbps Wireless N Nano Router

5.5.2LAN

Choose menu “Network → LAN”, and then you can configure the IP parameters of the LAN on the screen as below.

Figure 5-12 LAN

¾MAC Address - The physical address of the LAN ports, as seen from the LAN. The value can't be changed.

¾IP Address - Enter the IP address of your Router in dotted-decimal notation (factory default: 192.168.0.254).

¾Subnet Mask - An address code that determines the size of the network. Normally use 255.255.255.0 as the subnet mask.

)Note:

1.If you change the IP Address of LAN, you must use the new IP Address to login to the Router.

2.If the new LAN IP Address you set is not in the same subnet with the previous one, the IP Address pool in the DHCP server will be configured automatically，while the Virtual Server and DMZ Host will not take effect until they are re-configured.

5.5.3MAC Clone

Choose menu “Network → MAC Clone”, and then you can configure the WAN MAC address on the screen below, as shown in Figure 5-13:

Figure 5-13 MAC Address Clone

- 64 -