Xerox 8825, 8850, 8830, X2 manual A. Standard Stacker

A. Standard Stacker

The Stacker is located at the rear of the Scanner. When the AUTORETURN feature is set to REAR, documents exit the Scanner onto the Stacker. The Stacker can be adjusted to any one of four positions by raising or lowering it. The height of the Stacker should be adjusted to accommodate the document being scanned. It has two extensions at its end that can be pulled out to accommodate longer documents (up to size E or A0). When scanning most common weight (20 lb, 80gsm) documents, move the Stacker to the 2nd rung from the bottom.

NOTE: All thick documents and documents over 36 inches (914 mm) exit from the rear of the Scanner (regardless of the AUTORETURN setting). When scanning thick documents, the Stacker must be set to the lowest position for optimum performance.

B. Document Exit Slot

When the DOCUMENT RETURN feature is set to REAR, documents exit the Scanner through this slot and are delivered to the rear Stacker.

C. Power On/Off Switch

This switch turns the Scanner on and off. Press this switch to the on (I) position to turn on the Scanner and to the off (O) position to turn off the Scanner.

D. The Power Cord supplies power to the Scanner. Plug one end of the cord into the Scanner and the other end into an electrical outlet.

E.Status LED

The digital status LED provides an indication of the condition of the scanner and communications with the controller. A P displayed on the LED Display on the rear of the scanner indicates that the scanner is operating normally and has established communications with the controller.

F. IEEE 1394 Cable and Connector

The IEEE 1394 Cable is the communications link between the Scanner and the Controller. Plug one end of the cable into either one of the IEEE 1394 connections at the rear of the Scanner. Plug the other end into the IEEE 1394 connection on the Controller.

6 ∙Getting to know the WIDE FORMAT COPY SYSTEM XEROX WIDE FORMAT COPY SYSTEM