Xerox X2, 8825, 8850, 8830 manual Sets Build key, Sets Build Collation:Forward, Output Bin, Bypass

OUTPUT BIN	The OUTPUT BIN option enables you to specify which finisher output bin
	to use for the finished output. The choices are DON'T CARE, BIN X
	(where X equals 1 to the actual number of finisher bins), FANFOLD, and
	BYPASS. BYPASS is the factory default setting.
		OUTPUT BIN
	OUTPUT BIN:
		BYPASS

Preparing to build the set

Building and printing the set

Sets Build key

The Sets Build mode allows you to scan a series of images and build an electronically collated set. Once the set is built, one or more collated copies can be printed.

NOTE: The Sets Build mode is not available unless the WIDE FORMAT COPY SYSTEM is in the COPY mode.

NOTE: Any of the finishing options can be changed during a Sets Build job. The option(s) must be changed before the document to be copied is inserted.

In Sets Build mode, documents of C (A2) size and larger are normally delivered to the rear of the Scanner after the scan. If the DOCUMENT RETURN parameter is set to REAR, then all documents are delivered to the rear after scanning. The WIDE FORMAT SCAN SYSTEM is equipped with a document catching device, called the Stacker, to receive these documents. Refer to "Scanner Control" in the "Main Menu" section of this manual for further information about the DOCUMENT RETURN parameter.

To build a collated set:

1.Press the Sets Build key. The Sets Build indicator lamp illuminates and the SETS BUILD screen are displayed.

SETS BUILD

COLLATION: FORWARD

XEROX WIDE FORMAT COPY SYSTEM Special features keys ∙ 69