Chapter 10 Jobs

5.Press [OK].

The screen displays DRIVE=drive_name.

6.Turn the dial as necessary to select the disk (partition) you wish to import from.

To import from floppy disk, select DRIVE=FDD. (This selection is forced if you have not mounted a SCSI drive.)

To import from a SCSI disk, select DRIVE=SCSI (if the disk is unpartitioned) or DRIVE=SCSI Px (where x is the partition number).

7.After selecting the drive, press [OK].

The screen shows the volume name of most recently selected volume on the se- lected drive: VOLUME=volume name. (If you are importing from floppy disk, then the name is always FD VOLUM.)

If you have selected FDD or a removable-disk SCSI device and no disk is present, the screen will display NO DISK. If you have selected a disk that does not contain any volumes, the screen will display VOLUME=(NONE). If you are using a foreign disk with an unsupported format, the screen displays UNKNOWN FORMAT. In any of these cases, press [CANCEL] as necessary to return to a previous step or to escape from the job.

8.If you are importing from a SCSI drive, turn the dial as necessary to select the volume containing the sample that you want. (Remember that floppy disks hold a single vol- ume only; if you are importing from floppy disk, therefore, you will not be able to change the selection).

▼ The screen displays SAMPLE=sample_name, where sample_name is the name of one of the samples in the selected volume.

If the volume on disk contains no samples, the screen displays NO SAMPLES. Press [CANCEL] as necessary to return to a previous step or to escape from the job.

9.Turn the dial as necessary to select the sample that you wish to import, by its filename.

286

Chapter 10 Jobs