Chapter 10 Jobs
Use these jobs to set various system and MIDI parameters and to view remaining sequence memory and sampling time.
What The Jobs Do
SETUP Selects the ribbon function, and sets the metronome, the recording countdown, the recording mode, the pad sensitivity, and the
MIDI Sets the various MIDI parameters.
SCSI Sets SCSI IDs (local ID and remote ID). MEMORY Shows remaining sample and sequence memory.
SYSTEM SETUPUse to: Make various system settings.
●These settings are stored in nonvolatile memory, and are not lost at power- off.
●These settings are common to all songs.
●Changes that you make on these screens become effective immediately.
●The following jobs are available.
METRONOME Sets up the metronome.
COUNTDOWN Sets the countdown (number of
REC MODE Selects the mode used to record songs (either “overdub” or “replace”).
PAD SENS Sets pad velocity sensitivity on or off.
AUDIO IN Selects the audio input source.
RIBBON
Selects the function to be controlled by the ribbon.
FUNCTION
<METRONOME>
Use this job to set up operation of the metronome. The CLICK parameter selects the conditions under which metronome sound is produced, and the OUT parameter selects the output destination for the metronome sound.
CLICK = OFF | Metronome is always off. (No metronome click.) This is the |
| factory default setting. |
REC | Metronome click is produced only during song recording. |
REC/PLAY | Metronome click is produced during both song recording and |
| song playback. |
298 | Chapter 10 Jobs |