Chapter 10 Jobs
NOTE:
If you set the value to EXTERNAL or MTC SLAVE, the sequencer will operate only if the corresponding synchronization signal is being received.
Procedure
Be sure that you have selected the song whose synchronization you want to set.
1. Press SYSTEM MIDI to enter this job. Then turn the dial as necessary to select SYNC, and press [OK].
2. Turn the dial to set the SYNC parameter, the press [OK].
3. Turn the dial to select the setting.
4.
<CHANNELS>
Use this job to set the MIDI channel settings for each sample track (each LOOP, COMPOSED LOOP, and FREE track). Note that you can not make channel settings for the AUDIO IN and MASTER tracks.
Specifically, for each track you can set a Receive channel (RECEIVE), a Transmit channel (TRANS), and the note number to be transmitted over the Transmit channel. The factory default settings are OFF, OFF, and C3, respectively.
RECEIVE= 1,..,16, OFF
This parameter sets the MIDI channel that drives the selected track. The track will only respond to messages received over the MIDI channel you select here. If you set the value to OFF, the track will not respond to any MIDI channel messages (Note On messages, Control Change messages, etc.).
You cannot assign a RECEIVE channel number more than once: each channel number 1 to 16 can be selected for a maximum of one track only. This means that it is not possible to assign RECEIVE channels for more than 16 of the 40 sample tracks (where each of these 16 tracks must take a different channel number).
TRANS = 1,...,16, OFF
This parameter sets the MIDI channel over which the track sends MIDI messages (Control Change messages, Note On and Note Off messages, etc.). If you set the value to OFF, the track will not transmit any MIDI channel messages. You can set channel values for all 40 sample tracks; there are no restrictions on channel duplication.
304 | Chapter 10 Jobs |