FCC INFORMATION (U.S.A.)

1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!

regulations does not guarantee that interference will not occur in

This product, when installed as indicated in the instructions con-

all installations. If this product is found to be the source of inter-

ference, which can be determined by turning the unit “OFF” and

tained in this manual, meets FCC requirements. Modifications not

“ON”, please try to eliminate the problem by using one of the

expressly approved by Yamaha may void your authority, granted

following measures:

by the FCC, to use the product.

Relocate either this product or the device that is being affected by

2. IMPORTANT: When connecting this product to accessories and/

or another product use only high quality shielded cables. Cable/s

the interference.

Utilize power outlets that are on different branch (circuit breaker

supplied with this product MUST be used. Follow all installation

instructions. Failure to follow instructions could void your FCC

or fuse) circuits or install AC line filter/s.

authorization to use this product in the USA.

In the case of radio or TV interference, relocate/reorient the an-

3. NOTE: This product has been tested and found to comply with

tenna. If the antenna lead-in is 300 ohm ribbon lead, change the

the requirements listed in FCC Regulations, Part 15 for Class “B”

lead-in to co-axial type cable.

digital devices. Compliance with these requirements provides a

If these corrective measures do not produce satisfactory results,

reasonable level of assurance that your use of this product in a

please contact the local retailer authorized to distribute this type

residential environment will not result in harmful interference with

of product. If you can not locate the appropriate retailer, please

other electronic devices. This equipment generates/uses radio

contact Yamaha Corporation of America, Electronic Service Divi-

frequencies and, if not installed and used according to the instruc-

sion, 6600 Orangethorpe Ave, Buena Park, CA90620

tions found in the users manual, may cause interference harmful

The above statements apply ONLY to those products distributed

to the operation of other electronic devices. Compliance with FCC

by Yamaha Corporation of America or its subsidiaries.

 

 

 

* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA.

(class B)

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

IMPORTANT NOTICE FOR THE UNITED KINGDOM

Connecting the Plug and Cord

IMPORTANT. The wires in this mains lead are coloured in accordance with the following code:

BLUE

:

NEUTRAL

BROWN

:

LIVE

• This applies only to products distributed by Yamaha Canada Music Ltd.

(polarity)

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured makings identifying the terminals in your plug proceed as follows:

• Ceci ne s’applique qu’aux produits distribués par Yamaha Canada Musique Ltée.

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.

Making sure that neither core is connected to the earth terminal of the three pin plug.

(2 wires)

This applies only to products distributed by Yamaha-Kemble Music (U.K.) Ltd.