Zebra Technologies 110PAX4, R110PAX4 Table 20 • Applicator Interface Connector Pin Configuration (Continued)

Data Ports 141

Applicator Interface Connector

Table 20 • Applicator Interface Connector Pin Configuration (Continued)

Pin	Signal Name	Signal Type	Description
No.
5	PAUSE	Input	To toggle the current Pause state, this input must be
			asserted LOW for 200 milliseconds, or until the
			SERVICE REQUIRED output (pin 10) changes state.
6	REPRINT	Input	• If the Reprint feature is enabled, this input must be
			asserted LOW to cause the print engine to reprint the
			last label. See Set Reprint Mode on page 86 for more
			information.
			• If the Reprint feature is disabled, this input is ignored.
7	+28 V	Power	The Interface Power Supply. Supplies power to external
	(Fused at 500 mA.		sensors as required.
	See Figure 41		Note • If operating with 28V signals only, pin 7
	on page 145 for fuse		may be used to supply power to pin 2, which
	location.)		creates a non-isolated mode of operation.
	Caution • Replace
	the fuse only with
	one of the same
	type and rating.
8	POWER GROUND	Ground	The Interface Power Ground.
	(+28 V DC Return)		Note • If pin 7 is used to supply power to pin 2,
			use this pin to ground pin 1.
9	RIBBON LOW	Output	Asserted if the Ribbon Low feature is enabled and the
			amount of ribbon remaining on the supply spool is below
			a specific threshold level (see Set Ribbon Low Mode
			on page 86).
			• For print engines with the Ribbon Low Output
			parameter, asserted HIGH or LOW depending on the
			ribbon low output mode selected. See Set Ribbon Low
			Output on page 86 for more information.
			• For print engines without the Ribbon Low Output
			parameter, asserted HIGH.
			If the Ribbon Low feature is disabled, this output lead is
			disabled.
10	SERVICE	Output	Asserted LOW in the following circumstances:
	REQUIRED		• the printhead is open
			• the ribbon or media is out
			• the print engine is paused (to disable this function, see
			Set Applicator Error Signal When Print Engine Pauses
			on page 84)
			• an operational fault occurs
			• a Resynch error occurs while the applicator Resynch
			mode is set to Error mode (see Select Resynch Mode
			on page 85)

6/29/11 110PAX4/R110PAX4 User Guide 57512L-004 Rev. A