Zebra Technologies 110PAX4, R110PAX4 manual 142

142Data Ports

Applicator Interface Connector

Table 20 • Applicator Interface Connector Pin Configuration (Continued)

Pin	Signal Name	Signal Type	Description
No.
11	END PRINT	Output	See Applicator Signals on page 138 for more information
			about the start and end print signals. See Set Applicator
			Port Mode on page 84 for more information about the
			modes.
			Note • A format (^XA ... ^XZ) that does not print
			will signal that it is being processed. However, it
			will not trigger an End Print signal because no
			motion/printing is required.
			• MODE 0—The applicator port is OFF.
			• MODE 1—Asserted LOW only while the print engine
			is moving the label forward; otherwise deasserted
			HIGH.
			• MODE 2—Asserted HIGH only while the print engine
			is moving the label forward; otherwise deasserted
			LOW.
			• MODE 3—(Default) Asserted LOW for 20
			milliseconds when a label is completed and positioned.
			Not asserted during continuous printing.
			• MODE 4—Asserted HIGH for 20 milliseconds when a
			label is completed and positioned. Not asserted during
			continuous printing.
12	MEDIA OUT	Output	Asserted LOW while there is no media in the
			print engine.
13	RIBBON OUT	Output	Asserted LOW while there is no ribbon in the
			print engine.
14	DATA READY	Output	See Applicator Signals on page 138 for more information
			about this signal.
			• Asserted LOW when sufficient data has been received
			to begin processing the next label format.
			• Deasserted HIGH when printing/processing stops after
			the current label format, either due to a pause condition
			or the absence of a label format.
15	SPARE	Output	To be determined.
(Non-
RFID)
15	VOID	Output	• Asserted LOW when the RFID transponder over the
(RFID)			antenna is “voided.”
			• Deasserted HIGH when the end print signal is asserted.

57512L-004 Rev. A 110PAX4/R110PAX4 User Guide 6/29/11