Configuration

 

71

 

 

 

 

 

 

Control Panel Parameters

 

 

 

 

Table 7 • Print Engine Parameters (Page 8 of 25)

 

 

 

 

 

 

Parameter

 

Action/Explanation

 

 

 

 

 

 

 

Set Early Warning for Maintenance

 

 

EARLY WARNING

 

 

 

 

 

 

When this parameter is enabled, the print engine provides warnings when

 

MAINT. OFF

 

 

 

the printhead needs to be cleaned.

 

 

 

 

 

 

Note • If necessary, update the number of labels per roll when

 

 

 

beginning use of the Early Warning System for Maintenance. The

 

 

 

print engine does not make any adjustments when power is turned

 

 

 

off and on.

 

 

 

Default: MAINT. OFF

 

 

 

Selections: MAINT. OFF, MAINTENANCE ON

 

 

 

To change the Early Warning settings:

 

 

 

1. When the LCD displays EARLY WARNING MAINTENANCE, press

 

 

 

the left or right oval to toggle between OFF and ON. (If you are

 

 

 

prompted for a password, enter your password using the instructions in

 

 

 

Change Password-Protected Parameters on page 60.)

 

 

 

2. Exit Setup mode and save changes to enable additional parameters

 

 

 

related to the early warning system.

 

 

 

3. Enter Setup mode again and go to the following parameters to enter the

 

 

 

printhead cleaning interval and the printhead life.

 

 

 

 

 

 

 

Set Printhead Cleaning Interval for Early Warning

 

HEAD CLEANING

 

 

 

This parameter appears only when Early Warning for Maintenance is

 

- 450M 1476 FT

+

 

enabled. This value should correspond to the length of the media or ribbon

 

 

 

 

 

 

roll that you are using.

 

 

 

Default: 450 M/1476 FT

 

 

 

Range: 100 M/328 FT to 450 M/1476 FT in 50 M increments

 

 

 

To change the value shown:

 

 

 

1. Press the left or right oval to set the printhead cleaning interval to the

 

 

 

desired number of inches of media or ribbon.

 

 

 

When the printhead reaches the set length, WARNING CLEAN

 

 

 

PRINTHEAD appears on the LCD. If the alert function is enabled, the

 

 

 

print engine generates an alert. When the printhead is opened and then

 

 

 

closed after a printhead cleaning warning is received, the LCD prompts

 

 

 

with HEAD CLEANED?.

 

 

 

 

 

 

 

Reset Printhead Cleaning Counter for Early Warning

 

HEAD CLEANED?

 

 

 

This parameter appears only when Early Warning for Maintenance is

 

NO

YES

 

enabled.

 

 

 

To reset the printhead cleaning counter:

1.Did you clean the printhead?

a.If you cleaned the printhead, press the right oval to select YES.

b.If you did not clean the printhead, press the left oval to select NO.

6/29/11

110PAX4/R110PAX4 User Guide

57512L-004 Rev. A