Zebra Technologies 110PAX4, R110PAX4 YES, YES, Range:, Default:, RIBBON LENGTH, MEDIA REPLACED, - 450M 1476 FT, RIBBON REPLACED, RIBBON REPLACED, WARNING RIBBON LOW

70Configuration

Control Panel Parameters

	Table 7 • Print Engine Parameters (Page 7 of 25)
Parameter		Action/Explanation
		Reset Media Counter for Early Warning
MEDIA REPLACED?
		This parameter appears only when Early Warning for Media is enabled.
NO	YES
		To reset the media counter:
		1. Did you replace the media?
		a. If you replaced the media, press the right oval to select YES.
		b. If you did not replace the media, press the left oval to select NO.
		Set Ribbon Length for Early Warning
RIBBON LENGTH
		This parameter appears only when Early Warning for Media is enabled and
- 450M 1476 FT	+
		the print engine is set for Thermal Transfer operation.
		Default: 450 M/1476 FT
		Range: 100 M/328 FT to 450 M/1476 FT in 50 M increments
		To change the value shown:
		1. Press the left or right oval to set the value to match the length of the
		ribbon that you are using.
		Based on the number entered, when the print engine detects that less
		than 15% of the ribbon remains, WARNING RIBBON LOW appears
		on the LCD. If the alert function is enabled, the print engine generates
		an alert. When the printhead is opened and then closed after a ribbon
		warning is received, the LCD prompts with RIBBON REPLACED?.
		Reset Ribbon Counter for Early Warning
RIBBON REPLACED?
		This parameter appears only when Early Warning for Media is enabled and
NO	YES
		the print engine is set for Thermal Transfer operation.
		To reset the ribbon counter:
		1. Did you replace the ribbon?
		a. If you replaced the ribbon, press the right oval to select YES.
		b. If you did not replace the ribbon, press the left oval to select NO.

57512L-004 Rev. A 110PAX4/R110PAX4 User Guide 6/29/11