Zebra Technologies 110PAX4, R110PAX4 ±0000, Range:, Range:, Default:, 0500 OHMS, LEFT POSITION, HEAD RESISTOR, Initial Value:, Default Value:, Adjust Left Position

Configuration 83

Control Panel Parameters

Table 7 • Print Engine Parameters (Page 20 of 25)

	Parameter		Action/Explanation
			Adjust Left Position
LEFT POSITION
			This parameter establishes how far from the left edge of a label the format
-	±0000	+	begins to print by adjusting horizontal positioning on the label. Positive
			numbers adjust the printing away from the main frame by the number of
			dots selected; negative numbers shift printing toward the main frame. The
			displayed value represents dots.
			Default: 0000
			Range: –9999 to +9999 dots
			To change the value shown:
			1. Press the left oval to move the cursor.
			2. Press the right oval to change between +/- and to increase the value of
			the digit.
			3. For a negative value, enter the value before changing to the minus sign.
			Set the Printhead Resistor Value
HEAD RESISTOR
			Caution • This parameter should be changed only by qualified service
-	0500 OHMS	+
			personnel. Do not set the value higher than that shown on the printhead.
			Setting a higher value may damage the printhead.
			This value is preset at the factory to match the resistance value of the
			printhead. It does not need to be changed unless the printhead or the main
			logic board is replaced.
			Initial Value: Factory-set to match the printhead shipped with your
			print engine.
			Default Value: 0500
			Range: 0500 to 2000

To set the printhead resistor value:

1.Before replacing the printhead, look for the label that shows the resistance value (Ω value) of the new printhead. Make note of this setting before installing the new printhead.

2.Press the left oval to move to the next digit position.

3.Press the right oval to increase the value of the digit.

6/29/11 110PAX4/R110PAX4 User Guide 57512L-004 Rev. A