Zebra Technologies 110PAX4, R110PAX4 Place a full ribbon roll, Figure 16 • Loaded Ribbon, To load ribbon, complete these steps:

Operations 47

Load Ribbon

Figure 16 • Loaded Ribbon

Left-Hand Right-Hand

Caution • While performing any tasks near an open printhead, remove all rings, watches, hanging necklaces, identification badges, or other metallic objects that could touch the printhead. You are not required to turn off the printer power when working near an open printhead, but Zebra recommends it as a precaution. If you turn off the power, you will lose all temporary settings, such as label formats, and you must reload them before you resume printing.

To load ribbon, complete these steps:

1.Place a full ribbon roll (1) onto the ribbon supply spindle (2) so that the ribbon rotates as shown, and then push the roll toward the print engine frame until it is fully seated.

Left-Hand

1

Right-Hand

1

2 2

6/29/11 110PAX4/R110PAX4 User Guide 57512L-004 Rev. A