Zebra Technologies 110PAX4, R110PAX4 +10, WEB S, MARK S, Range:, - NONE, MEDIA S, RIBBON S, MARK LED, Default:, MEDIA LED, MARK MED S, RIBBON LED, LCD ADJUST, Selections:, Default: NONE

Configuration 87

Control Panel Parameters

Table 7 • Print Engine Parameters (Page 24 of 25)

Parameter Action/Explanation

		These parameters are automatically set during the calibration procedure
WEB S.	073	and should be changed only by a qualified service technician. Refer to the
-	+	ZPL II Programming Guide for information on these parameters.
		To skip these parameters:
MEDIA S.	075
-	+	1. Press NEXT/SAVE repeatedly.
RIBBON S.	071
-	+
MARK S.	000
-	+
MARK MED S. 000
-	+
MEDIA LED	082
-	+
RIBBON LED	008
-	+
MARK LED	005
-	+
		Adjust LCD Display
LCD ADJUST	+10
		This parameter allows you to adjust the brightness of your LCD if it is
-	+	difficult to read.
		Default: 10
		Range: 00 to 19
		To change the value shown:
		1. Press the right oval to increase the value (increase brightness).
		2. Press the left oval to decrease the value (reduce brightness).
		Select Format Convert
FORMAT CONVERT
		Selects the bitmap scaling factor. The first number is the original dots per
- NONE	+	inch (dpi) value; the second, the dpi to which you would like to scale.
		Default: NONE
		Selections: NONE, 150 → 300, 150 → 600, 200 → 600, 300 → 600
		To change the value shown:
		1. Press the left or right oval to scroll through the options.
		Set RTS Take-Up Dancer Arm Calibration Value
RTS TAKEUP ARM
		This parameter is used as a diagnostic tool to monitor the voltage supplied
XXX		to the Ribbon Tensioning System Take-Up Dancer Arm. Refer to the
		Maintenance Manual for information.

6/29/11 110PAX4/R110PAX4 User Guide 57512L-004 Rev. A