Zebra Technologies 110PAX4, R110PAX4 and, LABELS, ) appear, PER ROLL, Default:, Parameter, EARLY WARNING, Range: 100 to, MEDIA DISABLED, MEDIA REPLACED, WARNING MEDIA LOW, Action/Explanation

		Configuration	69
		Control Panel Parameters
	Table 7 • Print Engine Parameters (Page 6 of 25)
Parameter		Action/Explanation
		Set Early Warning for Media
EARLY WARNING
		When this parameter is enabled, the print engine provides warnings when
MEDIA DISABLED
		labels are running low.
		Note • Update the number of labels per roll when beginning use of
		the Early Warning System. The print engine does not make any
		adjustments when power is turned off and on.
		Default: MEDIA DISABLED
		Selections: MEDIA DISABLED, MEDIA ENABLED

			To change the Early Warning settings:
			1. When the LCD displays EARLY WARNING MEDIA, press the left or
			right oval to toggle between ENABLED and DISABLED. (If you are
			prompted for a password, enter your password using the instructions in
			Change Password-Protected Parameters on page 60.)
			2. If you enable the Early Warning System, do the following:
			a. Exit Setup mode and save changes to enable additional parameters.
			b. Enter Setup mode again. The media and ribbon parameters
			(LABELS PER ROLL, MEDIA REPLACED, RIBBON
			LENGTH, and RIBBON REPLACED) appear.
			c. Adjust the settings as necessary (descriptions of each of these
			parameters follows).
			Set Number of Labels Per Roll for Early Warning
LABELS	PER ROLL
			This parameter appears only when Early Warning for Media is enabled.
-	0900	+
			This value should correspond to the number of labels per roll of the media
			that you are using.
			Default: 0900
			Range: 100 to 9999

To change the value shown:

1.Press the left oval to move the cursor.

2.Press the right oval to increase the value of the digit.

Based on the number entered, when the print engine detects that less than 15% of the labels remain, WARNING MEDIA LOW appears on the LCD. If the alert function is enabled, the print engine generates an

alert. When the printhead is opened and then closed after a media warning is received, the LCD prompts with MEDIA REPLACED?.

3.If you replaced the media, press the right oval to select YES to clear

the warning and reset the label counter. If you did not replace the media, press the left oval to select NO.

6/29/11 110PAX4/R110PAX4 User Guide 57512L-004 Rev. A