Zebra Technologies 110PAX4, R110PAX4 Standard Print Engine Parameters, +04.0, 2 IPS, 6 IPS, Range:, Range:, Range:, DARKNESS, SLEW SPEED, PRINT SPEED, Default: +04.0, Default: 6 IPS

64Configuration

Control Panel Parameters

Standard Print Engine Parameters

Table 7 shows parameters in the order in which they are displayed when you press NEXT after entering Setup mode.

Table 7 • Print Engine Parameters (Page 1 of 25)

	Parameter		Action/Explanation
			Adjust Print Darkness
DARKNESS		+04.0
			Darkness (burn duration) settings depend on a variety of factors, including
-		+	ribbon type, media type, and the condition of the printhead. You may adjust
			the darkness for consistent high-quality printing.
			Important • Set the darkness to the lowest setting that provides
			good print quality. If the darkness is set too high, the ink may
			smear,, the ribbon may burn through, or the printhead may wear
			prematurely.
			If printing is too light or if there are voids in printed areas, increase the
			darkness. If printing is too dark or if there is spreading or bleeding of
			printed areas, decrease the darkness.
			The FEED Self Test on page 122 can be used to determine the best darkness
			setting. You may want to adjust darkness while performing the PAUSE Self
			Test on page 121. Because the darkness setting takes effect immediately,
			you can see the results on labels that are currently printing. Darkness
			settings also may be changed by the driver or software settings.
			Default: +04.0
			Range: 00.0 to +30.0
			To change the value shown:
			1. Press the right oval to increase darkness.
			2. Press the left oval to decrease darkness.
			Adjust Print Speed
PRINT SPEED
			Adjusts the speed for printing a label (given in inches per second). Slower
2 IPS		+	print speeds typically yield better print quality. Print speed changes take
			effect upon exiting Setup mode.
			Range: 2 to 12 IPS for 203 dpi, 2 to 8 IPS for 300 dpi
			To change the value shown:
			1. Press the right oval to increase the value.
			2. Press the left oval to decrease the value.
			Adjust Slew Speed
SLEW SPEED
		+	Adjusts the speed for feeding a blank label (given in inches per second).
6 IPS			Default: 6 IPS
			Range: 1 to 12 IPS

To change the value shown:

1.Press the right oval to increase the value.

2.Press the left oval to decrease the value.

57512L-004 Rev. A 110PAX4/R110PAX4 User Guide 6/29/11