Zebra Technologies 110PAX4, R110PAX4 Default:, PRINT WIDTH, - 168 0/8 MM, Set Print Width

			Configuration	67
			Control Panel Parameters
		Table 7 • Print Engine Parameters (Page 4 of 25)
Parameter			Action/Explanation
			Set Print Width
PRINT WIDTH
			Determines the printable area across the width of the label given the
- 168 0/8 MM	+
			resolution of the print engine.
			Default: 168 0/8 MM for 203 dpi print engines; 168 0/12 MM for 300 dpi
			print engines
			Note • Setting the width too narrow can result in portions of the
			label not being printed on the media. Setting the width too wide
			wastes formatting memory and can cause printing off the label and
			on the platen roller. This setting can affect the horizontal position of
			the label format if the image was inverted using the ^POI ZPL II
			command.

To change the value shown:

1.Press the left oval to move the cursor.

2.Press the right oval to increase the value of the digit.

To change the unit of measurement:

1.Press the left oval until the unit of measurement is active.

2.Press the right oval to toggle to a different unit of measure (mm, inches, or dots).

6/29/11 110PAX4/R110PAX4 User Guide 57512L-004 Rev. A