68Configuration

Control Panel Parameters

 

 

 

Table 7 • Print Engine Parameters (Page 5 of 25)

 

 

 

 

 

Parameter

 

Action/Explanation

 

 

 

 

 

 

 

 

 

Set Maximum Label Length

 

MAXIMUM LENGTH

 

 

 

This parameter is used during the media portion of the calibration process.

 

39.0IN

988MM

 

 

 

Always set maximum label length to a value that is at least 1.0 in.

 

 

 

 

 

 

 

 

 

 

 

 

(25.4 mm) greater than the actual label length (Figure 22). If the value is set

 

 

 

 

to a smaller value than the label length, the print engine assumes that

 

 

 

 

continuous media is loaded, and the print engine cannot calibrate.

 

 

 

 

For example, if the label length is 5.0 inches (126 mm) including the

 

 

 

 

interlabel gap, set the parameter for 6.0 inches (152 mm). If the label length

 

 

 

 

is 7.5 inches (190 mm), set the parameter for 9.0 inches (229 mm).

 

 

 

 

Figure 22 • Label Length

}2

3 1

1Label length (including interlabel gap)

2Interlabel gap

3Set maximum label length to approximately this value

Default: 39.0 inches (988 mm).

Range: Values are adjustable in one-inch (25.4 mm) increments.

To change the value shown:

1.Press the right oval to increase the value.

2.Press the left oval to decrease the value.

57512L-004 Rev. A

110PAX4/R110PAX4 User Guide

6/29/11