84Configuration

Control Panel Parameters

 

 

 

Table 7 • Print Engine Parameters (Page 21 of 25)

 

 

 

 

 

 

 

Parameter

 

Action/Explanation

 

 

 

 

 

 

 

 

 

Set Applicator Port Mode

 

APPLICATOR PORT

 

 

+

Determines the action of the applicator port.

 

-

OFF

Note • Set this value as suggested by the applicator manufacturer.

 

 

 

 

Default: OFF

 

 

 

 

Selections: OFF, MODE 1, MODE 2, MODE 3, MODE 4

•OFF: The applicator port is off.

•MODE 1: Asserts the ~END_PRINT signal low while the print engine is moving the label forward.

•MODE 2: Asserts the ~END_PRINT signal high while the print engine is moving the label forward.

•MODE 3: Asserts the ~END_PRINT signal low for 20 milliseconds when a label has been completed and positioned. Not asserted during continuous printing modes.

•MODE 4: Asserts the ~END_PRINT signal high for 20 milliseconds when a label has been completed and positioned. Not asserted during continuous printing modes.

 

 

 

To change the value shown:

 

 

 

1.

Press the left or right oval to scroll through the options.

 

 

 

 

 

 

 

Set Applicator Error Signal When Print Engine Pauses

 

ERROR ON PAUSE

 

 

 

When this option is enabled and the print engine is paused, the print engine

 

- ENABLED

+

sets the applicator error state.

 

 

 

Default: ENABLED

 

 

 

Selections: ENABLED, DISABLED

 

 

 

To change the value shown:

 

 

 

1.

Press the left or right oval to toggle between the options.

57512L-004 Rev. A

110PAX4/R110PAX4 User Guide

6/29/11