Prestige 153/153X WAN Bridge/Routers
13.7.1 Upload RAS code
RAS (Remote Access Service) code refers to the firmware that controls the main function of the Prestige. Menu 24.7.1 shows you the instructions for uploading RAS code. If you answer yes to the prompt, the Prestige will reboot automatically. Press any key when you see the message “Press Any key to enter Debug Mode within 3 seconds.” to enter debug mode.
Once in debug mode, type atur and wait for your Prestige to respond with “Starting XMODEM upload” to begin uploading the new firmware (upload procedure varies depending on the software used to access your Prestige). After successfully uploading the new firmware, type atgo to restart your Prestige.
Menu 24.7.1
To load the RAS code, type "atur" while in debug mode and wait for "Starting XMODEM upload" before beginning to upload code. Type "atgo" after code has successfully loaded to start RAS.
Proceeding with the upload will erase the current RAS code.
Do You Which To Proceed:(Y/N)
Figure 13-11. Menu 24.7.1 - Uploading RAS Code
System Maintenance |
