BASIC RECORDING
This section explains how to record from the tuner, CD player, MD recorder or external equipment.
m
When an MD recorder or other optional equipment is connected to this unit, you can also record from an MD or the connected equipment.
For how to connect an MD recorder and other optional equipment, see page 17.
Q~
b
●
!!JJ......
ti
1 ““”’”””!’ J
Preparation
●Set the tape to the point where recording will start.
●Use Type I (normal) and Type II (high/CrOz) tapes for recording.
1Insert the tape to be recorded on into the deck.
Insert the tape with the side to be recorded on first facing out from the unit and the exposed side down.
5 Press the ● button to start recording.
When the selected function is CD, playback and recording start simultaneously.
When the selected function is MD or VI DEO/AUX, start playback.
To stop recording, press the ■ button.
To pause recording, press the II button. (Applicable when the source is TUNER, MD, VI DEO/AUX.) To resume recording, press again.
To start recording with the remote control
First press the ● button, and then press the > button within 2
seconds.
INSERTING BLANK SPACES
Insertion of
1 Press the ● button during recording or while in recording pause mode.
The. button flashes for 4 seconds and the tape runs without recording. After 4 seconds, the deck enters the recording pause mode.
2Press the II button to resume recording.
To insert a blank space of less than 4 seconds, press the ●
button again while the button is”flashing.
To insert blank spaces of more than 4 seconds, after the deck enters recording pause mode, press the . button again. Each time the button is pressed, a
I
— EJECT
2 Press the TAPE/REV MODE button to select the reverse mode.
To record on one side only, select Z.
To record on both sides, select 11 or (1).
3 Press the MODE button repeatedly until “DOLBY” appears on the display. Then, turn the MULTI JOG dial right or left to turn Dolby NR on or off within 10 seconds.
To record with DOLBY NR, turn the dial so that “DOLBY ON”
is displayed. (The Do NR indication also turns on.)
To record without DOLBY NR, turn the dial so that “DOLBY
oFF’r is displayed.
4 Press one of the function buttons and prepare the source to be recorded.
To record from a CD, press the CD button and load the disc.
To record from a radio broadcast, press the TUNER/BAND
button and tune in to a station.
To record from an MD, press the MD button and load an
MD.
To record from the connected source, press the VIDEO/
AUX button and prepare to play.
To erase a recording
1Insert the tape to be erased into the deck.
2Set the tape to the point where the erasure is to be started.
3Press the VIDEO/AUX button.
If an optional equipment is connected to the VIDEO/AUX jacks, turn it off.
4Press the ● button to start the erasure.
13 ENGLISH