INSTALLATION REQUIREMENTS
ToolsandParts
Assemble the necessary tools and supplies before beginning the washer installation. The parts supplied are in the washer basket. Do not put the expanded foam plug back into the washer.
Tools needed for connecting the drain hose and water inlet hoses
■Pliers that open to 1 ⁹⁄₁₆" (3.95 cm)
■Flashlight (optional)
Parts supplied:
ABC
A. Drain hose “hook”
B. Water inlet hoses (2)
C. Flat water inlet hose washers (4)
Tools needed for securing the drain hose and leveling the washer
■Adjustable or open end wrench ⁹⁄₁₆" (14 mm)
■Level
■Wood block
■Ruler or measuring tape
Parts supplied:
A
BC
A. Beaded tie strap
B. Front leveling feet with nuts (2)
C. Rear
Alternate Parts You May Need
Your installation may require additional parts. If you are interested in purchasing one of the items listed here, call the
If You Have | You Will Need to Buy |
|
|
Laundry tub or | Sump pump system (if not already |
standpipe taller | available) |
than 96" (2.4 m) |
|
|
|
1" (2.5 cm) | 2" (5 cm) diameter to 1" (2.5 cm) |
diameter | diameter standpipe adapter, |
standpipe | Part Number 3363920 |
|
|
Overhead sewer | Standard 20 gal. (76 L) 39" (99 cm) tall |
| drain tub or utility sink and sump pump |
| (available from local plumbing suppliers) |
|
|
Floor drain | Siphon break, Part Number 285834; |
| additional drain hose, |
| Part Number 8318155 and connector |
| kit, Part Number 285835 |
|
|
Drain hose too | Drain hose, Part Number 8329541 and |
short | connector kit, Part Number 285835 |
|
|
Lint clogged drain | Drain protector, Part Number 367031 |
| and connector kit, Part Number 285835 |
|
|
Water faucets | 2 longer water fill hoses: |
beyond reach of | 6 ft (1.8 m) Part Number 76314, |
fill hoses | 10 ft (3.0 m) Part Number 350008 |
LocationRequirements
Selecting the proper location for your washer improves performance and minimizes noise and possible washer “walk.”
Your washer can be installed in a basement, laundry room, closet, or recessed area. See “Drain System.”
IMPORTANT: Do not install or store the washer where it will be exposed to the weather.
Proper installation is your responsibility.
You will need:
■A water heater set to deliver 120°F (49°C) water to the washer.
■A grounded electrical outlet located within 4 ft (1.2 m) of where the power cord is attached to the back of the washer. See “Electrical Requirements.”
■Hot and cold water faucets located within 4 ft (1.2 m) of the hot and cold water fill valves, and water pressure of
■A level floor with a maximum slope of 1" (2.5 cm) under entire washer. Installing the washer on carpeting is not recommended.
■A sturdy floor to support the washer weight (washer, water and load) of 315 lbs (143 kg).
Do not store or operate your washer in temperatures at or below 32°F (0°C). Some water can remain in the washer and can cause damage in low temperatures. See “Washer Care” for winterizing information.
4