SecureDrainHose
1.Drape the power cord over the console.
2.Move the washer to its final location and remove any cardboard used to move washer.
3.Locate the beaded tie strap (supplied).
Beaded tie strap
4.Wrap the drain hose to the laundry tub leg or standpipe with the tie strap. (See illustrations A and B.)
ABC
If the washer faucets and the drain standpipe are recessed, put the hooked end of the drain hose in the standpipe. Tightly wrap the tie strap around the water inlet hoses and the drain hose. (See illustration C.)
Do not force excess drain hose back into the rear of the washer.
Level Washer
Properly leveling your washer prevents excessive noise and vibration.
1.Check the levelness of the washer by placing a level on the top edge of the washer, first side to side, then front to back.
2.If the washer is against a wall, move the washer out slightly before tipping back. If the washer is not level, prop up the front of the washer with the wood block and adjust the feet up or down as necessary. Repeat this step until washer is level.
3.After the washer is in the final location and level, use a ⁹⁄₁₆" (14 mm)
IMPORTANT: If the nuts are not tight against the washer cabinet, the washer may vibrate.
4.Tilt the washer forward until the rear of the washer is at least 4" (10.2 cm) off the floor. You may hear the
CompleteInstallation
1.Check the electrical requirements. Be sure that you have the correct electrical supply and the recommended grounding method. See “Electrical Requirements.”
2.Check to be sure all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
3.Check to be sure you have all of your tools.
4.Dispose of/recycle all packaging materials. Keep the expanded foam plug for use if the washer should be transported.
5.Check to be sure the water faucets are on.
6.Check for leaks around faucets and inlet hoses.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
7.Plug into a grounded 3 prong outlet.
8.Remove the protective film on the console and any tape remaining on the washer.
9.Read “Washer Use.”
10.To test your washer, measure ¹⁄₂ the normal recommended amount of powdered or liquid High Efficiency detergent and pour it into the detergent dispenser. Close the lid. Select any cycle, and then press START. Allow it to complete one whole cycle.
8