Cleaning and care
Cleaning the dryer
d WARNING d
TO AVOID
RISK OF EXPLOSION!
3.Remove the lint filter.
4.Remove lint by stroking your hand over the filter.
qVacuum and reconnect the duct.
d WARNING d
Remove gas connection before moving the dryer to clean the duct. Be careful not to destroy the gas connection when cleaning the duct.
Cleaning the moisture sensor
The moisture sensor has to be cleaned because a fine layer of transparent buildup is deposited on the sensors.
|
|
|
| The filter should be lightly scrubbed | |||
|
|
|
| twice a year with warm soapy | |||
|
|
|
| ||||
Wipe the housing and | fascia with a | The filter | is cleaned | when it | |||
soft cloth and soapy | water | only. | water. | ||||
no longer holds | water. The | filter | |||||
Wipe the drum, door | seal |
|
| must be dried thoroughly before | |||
and inside |
|
|
| ||||
of the door with a damp | cloth | being | replaced. |
|
| ||
only. |
|
|
|
Cleaning the lint filter
A dirty filter extends the drying time and increases energy consumption.
The filter should be cleaned before and after each drying process.
If a warning signal and an E01 warning message are emitted during a drying program, clean the filter immediately and check the exhaust duct.
5.Insert the filter.
6.Close the door.
i
The program interrupts automatically.
Cleaning the exhaust duct
1. Switch | off | the dryer. | Program | Inspect | and | clean | the exhaust |
| |||||
selector | to | •Off". |
|
| ducting | at least once a year to | |||||||
d | CAUTION | d | prevent | clogging. | A | partially |
| ||||||
clogged | exhaust | can lengthen | the | ||||||||||
|
| drying time. |
|
|
|
|
| ||||||
The inside of the door heats | up |
|
|
|
|
| |||||||
during | the | drying process. |
| q | Turn | off | the | circuit breaker | |||||
|
|
|
|
|
| q | Pull | out | power | supply plug | |||
2. Open the | door. |
|
| ||||||||||
|
| q | Close the | shutooff valve. |
| ||||||||
|
|
|
|
|
|
| |||||||
|
|
|
|
|
| q | Disconnect | the | duct from | the | |||
|
|
|
|
|
|
| dryer. |
|
|
|
|
|