Clarity C4210 manual Maintenance and Care, Delete Caller ID Information

TELEPHONE OPERATIONS

5.Pressing the UP (▲) key will show blinking 413-456-7890 again.

Delete Caller ID Information

While reviewing the Caller ID, press DEL/CH button to delete the displayed caller information. LCD will flash DELETE ?.

Press DEL/CH to confirm. CID DELETED will be displayed for 2 seconds.The next record is shown automatically or - NO CALLS - if the list is empty.

•At anytime, the user can press FLASH button one time to go back to standby mode.

Or

•It will go back to standby automatically at 30 seconds time out if there is no action.

Deleting All Caller ID Information

While reviewing the Caller ID, press and hold the DEL/CH button for two seconds. LCD will flash DELETE ALL?. Press DEL/CH to confirm. LCD will display ALL CID and DELETED for 2 seconds and then - NO CALLS -.

•At anytime, the user can press FLASH button one time to go back to standby mode.

Or

•It will go back to standby automatically at 30 seconds time out if there is no action.

The C4210 has been designed to give you years of dependable service with a minimum of care.To ensure the utmost in performance, follow these guidelines in caring for the unit:

1.Avoid dropping or knocking the unit.

2.Dust the unit regularly.Wipe the unit with a soft damp cloth.

MAINTENANCE AND CARE

3.Do not use detergents and avoid excess moisture.

4.The C4210 is an electrical device.Avoid electric shock by keeping the phone away from water (i.e. bathroom, kitchen sink, etc.).

The unit will not operate/no dial tone:

•Verify the TALK Button is lit.

•Verify the AC Adapter is securely plugged into AC outlet, the base and the telephone.

•Verify the telephone line cord is securely plugged into the wall jack and the telephone.

•Make sure the base antenna is in an upright position.

•Make sure the handset battery is fully charged.

•Verify the telephone is in the correct dialing mode, tone (touch) or pulse (rotary).

•Make sure you are in the usable range of the base station.

•Reset the security code by placing the handset in the base for 5-10 seconds.

The phone does not ring when you receive a call:

•Make sure the RINGER switch on the handset and base are set to ON.

•Verify the AC Adapter is securely plugged into AC outlet, the base and the telephone.

•Verify the telephone line cord is securely plugged into the wall jack and the telephone.

•Make sure you are in the usable range of the base station.

•You may have too many extensions on your line.Try unplugging a few devices.

36 37