Handset Battery Installation

GETTING STARTED

The C4210 uses a 3.6Volt 600mAh NiMH recharge- able 3 cell (AAA Type) battery that is included with your unit.

Handset Battery must be connected before beginning initial charging.

Battery Life

A fully charged battery provides an average talk time of about four (4) hours, or standby time of about (8) days.Talk time and standby time may vary depending on operating conditions.

Talk Time: about four (4) hours

Standby Time: about eight (8) days

Battery

Connector

Battery

Pack Plug

Battery

Compartment

Cover

Installing and connecting battery

Note:The battery in the handset must be fully charged for 12 hours before using the telephone for the ﬁrst time.

To Install a New Battery

1.Remove battery cover

2.Install new battery

3.Connect battery pack

4.Replace battery cover

5.Charge for 12 hours before ﬁrst use

Handset Battery Charging

1.Place the handset in the base.The CHARGE LED on the base will light RED.

2.After the batteries are fully charged, check for dial tone by pressing TALK on the handset.

Low Battery

When the handset battery gets low, there will be two (2) beeps every thirty (30) seconds. If the bat- tery becomes low while you are on a call, you will be disconnected after about two (2) minutes.Terminate the call and recharge the battery.To recharge the battery pack, place the handset in the base.

1.Make sure the contact points are touching and the CHARGE LED is lit.

2.Be careful not to short battery with Conducting materials such as rings, bracelets and keys.

Headset Jack

You can use this telephone hands-free when you install a 2.5mm headset (purchased separately).To install, plug the headset into the HEADSET JACK at the top of the handset.While in headset mode, the volume of headset is controlled by the tele- phone and the handset’s earpiece and microphone are disconnected.

Ordering a Headset

In the event you wish to purchase a headset for your C4210, please contact Plantronics at 1-800-544-4660 for a location near you.We recommend using the Plantronics M110 or M130 headset.

Belt Clip

You may choose to use the optional belt clip with your handset.

1.To attach slide belt clip down onto grooves. Press the tabs on the belt clip into the slots to attach.

2.To remove, lift one side of the belt clip with your thumbnail and push back.

Hearing Aid Compatibility

The handset has a special coil inside of it to couple the sound to hearing aids equipped with T-Switches/ T-Coils.