20.1.1 Walking COS
20.1 W
20.1.1 Walking COS
Description
A user can enter his extension number and extension personal identification number (PIN) (→ 5.1.6 Extension PIN (Personal Identification Number)) at another extension, to make the following types of call using his Class of Service, including TRS level, overriding the other extension’s Class of Service.
•CO line call
•TIE line call
•Intercom call
•External Relay Control (→ 5.1.8 External Relay)
After performing Walking COS, the following features are also available for the specified extension:
•Call Forwarding (FWD)/Do Not Disturb (DND) setting (→ 4.1.9 DND (Do Not Disturb), → 6.1.6 FWD (Call Forwarding))
•Incoming Call Distribution Group
•Absent Message setting (→ 1.1.1 Absent Message)
•Extension Dial Lock (→5.1.4 Extension Dial Lock)
•Time
•CLIP number setting (CLIP ID) (→ 3.1.13 CLIP (Calling Line Identification Presentation))
Conditions
•When a CO line call is made using Walking COS:
–the Class of Service of the specified extension is applied (→ 3.1.19 COS (Class of Service))
–the Itemized Billing code of the specified extension is applied (→ 1.1.3 ARS (Automatic Route Selection))
–the specified extension number is recorded on SMDR as the call originator, instead of the extension number of the actual extension used (→ 16.1.1 SMDR (Station Message Detail Recording)).
•Walking COS is also available through DISA. (→ 4.1.7 DISA (Direct Inward System Access))
•Extension PIN
An extension personal identification number (PIN) is required to use this feature (→ 5.1.6 Extension PIN (Personal Identification Number)). If the wrong PIN is entered three times, the line will be disconnected.
•This feature can not be used for extensions which the extension being operated is prevented from calling by Internal Call Block. (→ 9.1.14 Internal Call Block)
PC Programming Manual References
4.8
4.11
6.1
6.10
PT Programming Manual References
[005] Extension Personal Identification Number (PIN)
348
Feature Manual | Document Version |