4.1.7 DISA (Direct Inward System Access)
An outside party such as a cellular phone can transfer a CO line call to an extension at the PBX by pressing "#" + extension number, if DISA is connected by the Automatic DISA Activation feature. This feature can be enabled or disabled through system programming.
7.3
→
→
–The
–DISA security mode should be set to No Security or CO Line Security.
–If the called extension does not answer, is busy, or is in DND mode, the DISA Intercept feature operates.
–The party on hold can use the Call Retry feature.
–End of Call Detection does not operate after dialing "#".
–Calls can only be transferred to extensions within the PBX.
–Transfer Recall, Call Splitting and Call Transfer with Announcement are not available.
•DISA Reorder Tone Duration
It is possible to set the DISA Reorder Tone Duration time. This specifies the length of time that a reorder tone will be sent to the caller. When the timer expires, the call will be disconnected. Call Retry is possible during the DISA Reorder Tone Duration time.
4.4
•Call Deny
Extensions can deny DISA calls on a COS basis.
4.11
•Verification Code PIN Lock/Extension PIN Lock
If the wrong PIN is entered three times, the line will be disconnected. If the wrong PIN is entered a preprogrammed number of times successively, that extension or verification code will become locked, and even entering the correct PIN will not unlock it. Only an extension assigned as the manager can unlock it. In this case, the PIN will be unlocked and cleared.
4.4
•DISA Automatic Walking COS
–The
•Each outgoing message (OGM) can be assigned a name through system programming for programming reference.
7.4
Installation Manual References
KX-TDA50
2.5.3MSG2 Card
2.5.5ESVM2 Card
KX-TDA100/KX-TDA200
2.6.1OPB3 Card
2.6.5MSG4 Card
KX-TDA600
2.8.1OPB3 Card
2.8.4MSG4 Card
2.8.5ESVM4 Card
Document Version | Feature Manual |
83