3.1.2Call Hold
•Even if the caller’s name is sent, the name may not be shown depending on the type of SLT.
•Incoming Call Log information is not shown on the SLT
•Caller ID shows whether the call is an intercom or CO line call by default. This setting can be disabled through system programming.
•A caller ID name received from the network via a PRI23 card will not be displayed on an SLT. However, if the received caller ID matches a System Speed Dialing entry, and a name is registered for that entry, it will be displayed.
PC Programming Manual References
4.4
→ Caller
→ Caller
4.17
4.18
5.1
6.1
→ Extension Caller ID
→ Incoming Call Wait Timer for Extension Caller ID
8.1
5.3
PT Programming Manual References
[001]System Speed Dialing Number
[002]System Speed Dialing Name
[490]Caller ID Signal Type
Feature Manual References
16.1.1SMDR (Station Message Detail Recording)
16.1.3Speed Dialing, Personal
16.1.4Speed Dialing, System
3.1.2Call Hold
Description
An extension user can put a call on hold. The following Hold features are available:
Feature
Regular Hold
Exclusive Call Hold
Description
Any extension can retrieve a held call.
Only the extension user who held the call can retrieve it.
The result of the holding operation can be determined through system programming. Pressing the HOLD button again just after the first time alternates the mode between Regular and Exclusive Call Hold.
36
Feature Manual | Document Version |