COS Class of Service Paralleled Telephone

20.1.4Wireless XDP Parallel Mode

–Call Pickup Deny Setting (→ 3.1.6 Call Pickup)

–Executive Busy Override Deny Setting (→ 5.1.3 Executive Busy Override)

–Itemized Billing Code for Automatic Route Selection (ARS) (→ 1.1.3 ARS (Automatic Route Selection))

–Calling Line Identification Presentation (CLIP) Number and CLIP Number Selection (→ 3.1.13 CLIP (Calling Line Identification Presentation))

–Calling Line Identification Restriction (CLIR) and Connected Line Identification Restriction (COLR) Settings (→ 3.1.13 CLIP (Calling Line Identification Presentation))

–Extension Personal Identification Number (PIN) (→ 5.1.6 Extension PIN (Personal Identification Number))

–COS Programming (→ 3.1.19 COS (Class of Service))

–Extension User Group (→ 7.1.1 GROUP FEATURES)

–Transfer Recall Destination for Call Transfer and Call Park (→ 3.1.5 Call Park, → 3.1.8 Call Transfer)

•The PS will retain its original settings for the following items even when in Wireless XDP Parallel mode. These settings can be set on the wired telephone and PS independently, and the settings can be different.

–Ring Tone Pattern Table Selection (→ 15.1.2 Ring Tone Pattern Selection)

–Preferred Line Assignment—Incoming (→ 10.1.2 Line Preference—Incoming)

–Preferred Line Assignment—Outgoing (→ 10.1.3 Line Preference—Outgoing)

–Hot Line Setting (→ 8.1.6 Hot Line)

–Display Language (→ 4.1.8 Display Information)

–ISDN Bearer Mode (→ 9.1.16 ISDN (INTEGRATED SERVICES DIGITAL NETWORK) FEATURES)

–Flexible Button Assignment (→ 6.1.3 Flexible Buttons)

–Transfer Recall Destination for Call Transfer and Call Park (The setting assigned to the wired telephone will first be copied to the PS’s extension settings, then can be changed for the PS if necessary.) (→

3.1.5 Call Park, → 3.1.8 Call Transfer)

If an extension number is required when changing any PS settings while in Wireless XDP Parallel mode, use the original extension number assigned to the PS, not the extension number of the paired (wired) telephone.

•If the Extension Feature Clear is performed, the corresponding extension data for both the wired telephone and the PS will be cleared. (→ 5.1.5 Extension Feature Clear)

•When a call arrives, both the wired telephone and the PS will ring. However, when one of the following settings is made, only the telephone which was used to make the setting will ring.

–Automatic Callback Busy (→ 1.1.4 Automatic Callback Busy (Camp-on))

–Transfer Recall (→ 3.1.8 Call Transfer)

–Hold Recall (→ 3.1.2 Call Hold)

–Call Park Recall (→ 3.1.5 Call Park)