English
6.Follow the instructions for leveling the laser. TIP: Remember the front leveling knob controls the movement of the bubble in the front vial, the side leveling knob controls the movement of the bubble in the side vial.
7.Turn the laser on if not on already; adjust rotation speed and con- trols as needed.
Horizontal Leveling | A |
move the bubble in the front vial to the left, turn the leveling knob to the right. Repeat the procedure for the side vial.
6.Turn the laser on if not on already; adjust rotation speed and con- trols as needed.
7.To project a level laser reference plane, adjust the rotation speed for preferred visibility. Remember: Slow Speed = Bright Beam; Fast Speed = Solid Beam.
1. | Set the laser on a relatively smooth and | C |
| level surface such as a Tripod or pre- |
|
| pare the laser level to be attached to |
|
| wall track using the | B |
| feature. See “Wall Mount” section. |
|
2. | Use the |
|
| Adjustment Lever to pivot the laser |
|
| head to a level setting for projecting a |
|
Vertical Plumbing | D |
1.Set the laser on a relatively smooth and level surface. The 
tool should be positioned on the large base plate under the battery
pack. Utilize the Base Leveling B Knob (A) to roughly position the
laser.
C
A
horizontal reference beam. In this |
position the Manual Head Rotation |
Button (A) should be pointing up |
towards the ceiling or sky. |
3.The leveling knobs (B) control the
orientation of the laser head on the metal leveling plates and effect the movement of the bubbles in the vials (C). When the laser level is placed in a level position the front leveling knob controls the movement of the bubble in the front vial. The side leveling knob controls the movement of the bubble in the side vial. NOTE: The same leveling rules apply to the tool when being used with the Wall Mount feature.
4.To level the laser, the bubbles in both the front and side vials need to be centered within the vials. TIP: The more accurately you can center the bubbles within the vials the more accurate your hori- zontal laser reference beam will be.
5.To level the laser, turn the leveling knob towards the bubble until the bubble is centered in the vial. TIP: To move the bubble in the front vial to the right, turn the front leveling knob to the left. To
2.Use the
the laser head to a plumb setting for projecting a vertical reference beam. In this position the pivoting laser head should be directly over the Wall Mount Clamp and the Control Panel should be fac- ing up towards the ceiling or sky.
3.To plumb the laser, only the bubble in the Plumb Vial (D) needs to be centered. TIP: The more accurately you can position the bub- ble within the vial the more accurate your vertical laser reference beam will be.
4.Looking over the top of the laser, turn the Plumb Leveling Knob (B) (which is located on the side of the pivoting laser head in this ori- entation) to move the bubble within the Plumb Vial (D). Turn the plumb leveling knob towards the bubble until the bubble is cen- tered in the vial. TIP: Turn the knob in the opposite direction you need the bubble to move.
5.Use the Plumb Beam Alignment Knob (C )(which is the knob next to the Plumb Vial) to adjust the plumb laser reference plane over your mark.
12