AFTER TURNING THE LASER ON, 2 LASER DOTS ARE PROJECTED FROM THE ROTARY HEAD
The DW073 Cordless Rotary Laser has been designed with dual, side by side laser diodes. Two diodes allows the laser to avoid blind spots which could potentially be created by the protective cap over the rotary head and also produce an extremely bright beam when the rotary laser head is spun.
THE LASER IS PROJECTING 2 LASER LINES WHEN THE LASER HEAD IS ROTATED
Take the laser to a DEWALT service center for calibration.
THE POWER LED LIGHT IS FLASHING, THE ROTARY HEAD HAS STOPPED SPINNING AND THE LASER DIODES HAVE SHUT DOWN.
This indicates that the battery pack needs to be recharged. TIP: See “Removing the Battery Pack” and “Charging Procedures.”
THE BUMP SENSOR WARNING LED LIGHT IS FLASHING
See “Bump Sensor” section for operating instructions.
THE BUMP SENSOR WILL NOT TURN THE LASER OFF AFTER THE TOOL HAS GONE OUT OF LEVEL
The Bump Sensor is NOT AN OUT OF LEVEL SENSOR. See “Bump Sensor” section.
THE ROTATING LASER BEAM IS DIFFICULT TO SEE INDOORS
Ambient light conditions will influence the visibility of the laser beam. To aid in beam visibility, adjust the rotation speed using the ON/OFF VARIABLE SPEED SWITCH. Remember: Slow Speed = Bright Beam; Fast Speed = Solid Beam. Wearing the Laser Enhancement Glasses can also help you see the beam better.
I NEED TO ADJUST THE LASER FOR A VERTICAL / PLUMB ORI- ENTATION
See
I NEED TO ADJUST THE LASER FOR MOUNTING ON A WALL See “Wall Mount” section.
THE LASER ROCKS WHEN POSITIONED ON THE FLOOR
The laser is designed to sit on 3 contact points for maximum stability. Two of these contact points are stationary while the third is adjustable. To roughly position the tool on the floor adjust the Base Leveling Knob, which is located under the battery pack.
I NEED TO STOP THE ROTARY HEAD ROTATION TO DIRECT THE LASER DOT ONTO A MARK OR TO SET A MARK
See “Manual Head Rotation” section.
THE BUBBLE(S) IN THE VIAL(S) WILL NOT MOVE WHEN ATTEMPTING TO LEVEL THE LASER
The tool must be positioned on a relatively smooth and level surface before being leveled. The laser cannot be leveled if the tool is set up outside of its leveling range. TIP: Use the Base Leveling Knob to roughly level the tool before attempting to level the laser with the lev- eling knobs. TIP: Make sure that the
I CAN ONLY ADJUST THE BUBBLE IN THE PLUMB VIAL WHEN ATTEMPTING TO PROJECT A VERTICAL LASER LINE
See “Vertical Plumbing” section for instructions on projecting a vertical laser line.
COLD STORAGE INFORMATION
After storing this product in extremely cold conditions, the laser head may not immediately rotate when turned on. The rotary head may be started by depressing and turning the Manual Rotation Button counter- clockwise.
English
19