| Dialer Information |
|
|
EN 49
Table 45: | Dialing Digits |
| |
|
|
|
|
|
|
|
|
Digit | Number to | Digit | Number to |
Required | Program | Required | Program |
terminator | 0 | 8 | 8 |
1 | 1 | 9 | 9 |
2 | 2 | 0 | 10 |
3 | 3 | * | 11 |
4 | 4 | # | 12 |
5 | 5 | 4 sec pause | 13 |
6 | 6 | break | 14 |
7 | 7 | 15 | 15 |
11.1Primary Telephone Number for Receiver 1 and Receiver 2
Location 000 to 015 (Receiver 1)
Default 0
Location 040 to 055 (Receiver 2)
Default 0
When the control panel transmits a report, the panel dials the Primary Telephone Number to contact the monitoring station or pager, for example. If the call is successful, the relevant information is transmitted and the dialer returns to Standby Mode.
If unsuccessful, the dialer attempts two more calls using the Primary Telephone Number for Receiver 1. If these calls are unsuccessful, the dialer calls the Secondary Telephone Number for Receiver 1 up to three times. If the dialing sequence is still unsuccessful, the control panel repeats this sequence by dialing the Primary and Secondary Telephone Numbers for Receiver 2 (if they are programmed).
If the first six attempts are unsuccessful and no telephone numbers for Receiver 2 are programmed, this procedure is repeated only once for a maximum of twelve call attempts per alarm, after 10 min.
If the Primary and Secondary Telephone Numbers for Receiver 2 are also programmed, the control panel attempts a maximum of 24 calls per alarm.
Contact your monitoring station or pager company for the correct telephone numbers before you program these locations.
When Receiver 1 or 2 is set up for domestic reporting, telephone numbers programmed into these locations are ignored. Refer to Section 5.1.3 Change Domestic Phone Numbers on page 23 (using the Installer Code function) or Section 5.2.4 Changing Domestic Phone Numbers on page 28 (using the Master Code Function).
11.2Secondary Telephone Number for Receiver 1 and Receiver 2
Location 016 to 031 (Receiver 1)
Default 0
Location 056 to 071 (Receiver 2)
Default 0
Refer to Section 11.1 Primary Telephone Number for Receiver 1 and Receiver 2 on page 49 for programming information.
When Receivers 1 or 2 is set up for domestic reporting, telephone numbers programmed into these locations are ignored. Refer to Section 5.1.3 Change Domestic Phone Numbers on page 23 (using the Installer Code function) or Section 5.2.4 Changing Domestic Phone Numbers on page 28 (using the Master Code Function).
11.3Handshake Tone for Receiver 1 and Receiver 2
Location 032 (Receiver 1)
1HI LO handshake (Contact ID Format)
2 1400 Hz (Ademco Tx @ 1900 Hz)
3 2300 Hz (Low Speed Sescoa)
4 No handshake
5 Pager handshake
Location 072 (Receiver 2)
1HI LO handshake (Contact ID Format)
2 1400 Hz (Ademco Tx @ 1900 Hz)
3 2300 Hz (Low Speed Sescoa)
4 No handshake
5 Pager handshake
These locations set the type of handshake tone required for the receivers before data transmissions to the monitoring station begin.
1 – HI LO Handshake
HI LO Handshake Tone is required to communicate in Contact ID Format or High Speed DTMF.