| System and Consumer Options |
|
|
EN 80
For partitioned
17.14 Kiss-Off Wait Time
Location 490
Default 3
Increments of 500 ms (500 ms to 8 sec)
This location sets the time the control panel waits for acknowledgment before resending a report. This timer applies only to the 4 + 2 Express Format.
17.15 Speaker Beep Volume
Location 491
Default 13
0No beeps
15 Loudest beeps
This location allows you to adjust the speaker volume for remote radio operation.
17.16 System Time
Location 901 to 904
| Location | Default |
Hour of the day (tens digit) | 901 | 0 |
Hour of the day (units digit) | 902 | 0 |
Minute of the day (tens digit) | 903 | 0 |
Minute of the day (units digit) | 904 | 0 |
The
17.17 System Date
Location 905 to 910
| Location | Default |
Day of the month (tens digit) | 905 | 0 |
Day of the month (units digit) | 906 | 1 |
Month of the year (tens digit) | 907 | 0 |
Month of the year (units digit) | 908 | 1 |
Current year (tens digit) | 909 | 0 |
Current year (units digit) | 910 | 1 |
The
To set the date and time:
1.Enter your Master Code and press [6][AWAY]. Three beeps sound and the STAY and AWAY indicators flash.
2.Enter the day, month, year, hour, and minute in DD, MM, YY, HH, MM format (where DD is the day of the month, MM is the month of the year, YY is the year, HH is the hour of the day, and MM minute of the day) and press [AWAY]. Use 24:00 hour format when programming the hour of the day.
Two beeps sound and the STAY and AWAY indicators are extinguished. If a long beep sounds, there was an error when you entered the date and time.
Example
To set the date and time for the 1st January 2004 at 10:30 PM, enter:
[2 5 8 0 6][AWAY][0 1 0 1 0 4 2 2 3 0][AWAY]
18.0 System and Consumer Options
The locations in this section have up to four options. You can select any combination of these options by programming a single value. Calculate this value by adding the option bit numbers together. Refer to Section 7.3 Programming Option Bits on page 36 for more information.
18.1System Options 1
Location 492
1Bosch Security Systems, Inc. smart lockout allowed
2 Horn speaker monitor
4 Strobe indications for radio arm/disarm
8Assign Button 4 on transmitter to operate STAY Mode 1
1 – Smart Lockout Allowed
This feature allows the control panel to remove any zones that are programmed for lockout dialer from the lockout list when the sirens are running. This feature allows a monitoring station to receive zone alarm reports from previously locked out zones during siren time. Refer to Section 14.3.5 Zone Options 1 on page 61 for information on programming zones for lockout dialer and lockout siren.
Refer to Section 14.5 Swinger Shutdown Count for Dialer on page 64 to program the number of times the zone can report before being locked out.
2 – Horn Speaker Monitor
If this option is selected, the control panel detects when the horn speaker is disconnected from the speaker terminals. The FAULT indicator lights when the horn speaker is disconnected and is extinguished when the horn speaker is reconnected.
If an output is required to operate when the horn speaker is disconnected, use Output Event Type 1,6 Horn Speaker Monitor Fail (refer to page 72 for more information).