| Programmable Outputs |
|
|
EN 71
16.1Redirecting Outputs to the Codepad Buzzer
Multiple output event types can be directed to the codepad buzzer so that the buzzer can indicate a number of events.
To redirect an output to the codepad buzzer, select an output and program it for the desired Output Event Type. If the output is functioning correctly, add 8 to the first (tens) digit of the Output Event Type.
Example
3,0 Communications Failure
This event operates after the dialer makes all possible attempts to reach the base station receiver. It is reset when the panel receives the first
To redirect this Output Event Type to operate a codepad buzzer, program the Output Event Type as:
11,0 Communications Failure
The codepad buzzer operates instead of the output that was programmed. Output 3 is no longer functional and cannot be used for any other Output Event Type.
16.2Output Event Types
There are approximately 75 Output Event Types. Two numbers designate each Output Event Type. Program these numbers into the appropriate locations for the output.
All reset times reference Polarity 1 and 8. Reset times vary depending on the selected polarity.
0,0 EDMSAT - Satellite Siren (Output 1 Only)
This output controls all functions of the SS914 Satellite Siren (EDMSAT). The Speaker Indication Beeps option does not function through the satellite siren for remote operations. No polarity is required for this Output Event Type.
0,1 System Armed
This output operates when the system is armed. The output is reset when the system is disarmed. If the system is partitioned, this output operates when both areas are armed in AWAY Mode or STAY Mode 1.
0,2 System Disarmed
This output operates when the system is disarmed. The output is reset when the system is armed. If the system is partitioned, this output operates when both areas are disarmed.
0,3 Armed in STAY Mode
This output operates when the system is armed in STAY Mode 1 or STAY Mode 2. The output is reset when the system is disarmed. If the system is partitioned, this output operates when either area is armed in STAY Mode 1.
0,4 Armed in AWAY Mode
This output operates when the system is armed in AWAY Mode. The output is reset when the system is disarmed. If the system is partitioned, this output operates when either area is armed in AWAY Mode.
0,5 Auto Arm Pre-Arming Alert Time
This output operates during the time period before the control panel is automatically armed in AWAY Mode or STAY Mode 1. The output is reset when the control panel is automatically armed in AWAY Mode or STAY Mode 1. The Auto Arming
17.11for more information).
0,6 Exit Warning with All Zones Sealed or Entry Warning
This output operates during Exit Time when the control panel is armed and all zones are sealed. The output is reset when Exit Time expires.
This output operates again during Entry Time and is reset when Entry Time expires or the system is disarmed.
This output also operates if a zone is activated when the system is armed in STAY Mode 1 or STAY Mode 2 and the Entry Guard Timer for STAY Mode is programmed in Locations 472 and 473 (refer to Section 17.5 on page 78).
0,7 Exit Warning
This output operates during Exit Time when the system is armed. The output is reset when Exit Time expires.
0,8 Exit Warning Finished
This output operates after Exit Time expires when the system is armed. The output is reset when the system is disarmed.
0,9 Kiss-Off after Exit Time
This output operates after the first successful transmission to the base station receiver when Exit Time expires. The output is reset when the system is disarmed.
0,11 Entry Warning
This output operates when during Entry Timer 1, Entry Timer 2, or Entry Guard Timer for STAY Mode. The output is reset when the Entry Time expires.