POINTSPUNTADASSTRAIGHT
DROITS ETRECTASAND ZIGZAG
POINTS ZIGZAGY ZIGZAGESTITCHING
1
Straight Stitching
| Pattern | Stitch Length | Stitch Width | ||
| (Straight Stitch) | 3.5 | |||
| |||||
| |||||
|
|
|
|
| |
|
|
|
|
| |
| (Triple Stretch Stitch) |
|
|
| |
|
| SS |
|
| |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
STARTING SEWING
1.Raise the needle to its highest position and lift the presser foot lever before changing the stitch selection, stitch length or stitch width.
2.Turn the Pattern Selection Dial to show Straight Stitch or Triple Stretch Stitch in the Pattern Indication Window.
3.Pull the upper thread toward the back of the presser foot.
4.Place the fabric under the presser foot and position the needle 1 cm (3/8") from the edge of the fabric.
5.Lower the presser foot.
6.To backtack, push down the Reverse Sewing Lever as far as possible, then step down on the foot controller to start reverse sewing.
7.Release the Reverse Sewing Lever and start sewing in the forward direction by applying pressure to the foot controller.
*Reverse sewing is used for locking the end of seams and where reinforcement is needed.
CAUTION
Be sure the needle does not strike a basting pin, or any other objects, during sewing. The thread could tangle or the needle could break, causing injury.
CHANGING SEWING DIRECTION
1.Stop the machine at the point where you wish to change direction with the needle still in the fabric.
2.Raise the presser foot and turn the fabric to line up its new direction using the needle as a turning point.
3.Lower the presser foot and start sewing in the new direction.
FINISHING SEWING
Reverse stitching is used to lock the threads at the end of the seam or wherever reinforcement is needed.
1.Stitch to the end of the seam and stop.
2.Push the Reverse Sewing Lever and stitch backwards for 1 cm (3/8") from the end of the fabric.
REMOVING THE MATERIAL FROM THE MACHINE
1.Stop the machine.
Raise the needle to its highest position and make sure that the thread
2.Lift the presser foot and pull the fabric out gently to the left side.
3.Cut both threads with the thread cutter located on the left side of the machine.
1 Thread cutter
4.To prepare the machine for the next seam, pull about 10 cm (4") of thread under the presser foot toward the back of the machine.
TOP STITCHING AND STRETCH MATERIALS
Straight Stitch is used for top stitching and sewing lightweight fabrics.
Triple Stretch Stitch is used for stretch fabrics.
35