Brother Sewing Manching manual Using the Walking Foot

UTILISATIONDES ACCESSOIRESAPPLICATIONSLEURSET	USODE USINGATTACHMENTSAPPLICATIONS ACCESORIOSAPLICACIONES AND Y
	A
	1
	2

1

B

C

63

Using the Walking Foot

Pattern	Stitch Length	Stitch Width
(Straight Stitch)	1-4.5	3-4
(Zigzag Stitch)		0-6.5

This foot is very useful for sewing materials such as vinyl cloth, synthetic leather, thin leather, etc. These materials are difficult to feed when sewing. The walking foot prevents such materials from crumpling, slipping or sticking between presser foot and material due to even feeding of upper and lower materials.

NOTE:

Use this foot only for straight sewing and zigzag stitching. Do not use other patterns.

1.Remove the power supply plug from the outlet.

2.Raise the needle and the presser foot.

3.Loosen the presser foot holder screw to remove the presser foot holder. (See fig. A)

4.Attach the forked section of the connecting lever to the needle clamp, install the walking foot to the presser bar. (See fig. B)

5.Lower the presser foot lever and then tighten the presser bar holder fixing screw. (See fig. C)

1Forked part of operation lever

2 Presser bar holder

1Use a screwdriver

CAUTION

•Use the screwdriver to tighten the screw securely. If the screw is loose, the needle may strike the presser foot and cause injury.

•Be sure to turn the handwheel toward the front of the machine to check that the needle does not strike the presser foot. If the needle strikes the presser foot, injury may result.

•Be careful not to touch the needle when attaching the walking foot, otherwise injury may result.

CAUTION

When sewing with the walking foot, sew at medium to low speeds.