Bosch Appliances PGL985UC manual Before the first start-up, For appliance usage, Burner

Before the first start-up

Remove the packaging from the appliance and dispose of it as per local laws. Remember that there are other accessories in addition to packaging materials. Keep packaging materials and plastic bags out of the reach of children.

Check the condition of the appliance before installing it, to ensure that it has suffered no damage during transport.

Only authorized technical personnel must install and connect the appliance before its first start-up in compliance with the regulations of the gas supplier companies and local.

Turn the control dials to before connecting the appliance to the current supply.

The appliance's serial number is indicated on the control slip annexed to this manual. For warranty purposes, keep this note together with the usage and assembly instructions.

Carefully read the assembly and usage instructions before starting up the appliance.

Thoroughly clean the appliance and accessories when using them for the first time. This will eliminate any "new" scents and any remaining dirtiness (see cleaning and care chapter).

For appliance usage

The use of this gas burning appliance produces a formation of heat and humidity in the area of use. Make sure that the area has proper ventilation conditions.

Keep the ventilation channels open. Prolonged use of the appliance with several or all cooking units may require additional ventilation, such as opening a window or a door or more intensive extraction of air with an extraction hood.

To guarantee good combustion, the room in which the appliance is installed must have a minimum volume of 1240 cft (35 m3) and must possess a door that opens outdoors or a window that can opened.

The use of spit-roasters, pans or grilling stones simultaneously by more than one burner is prohibited, as the accumulation of heat could damage the appliance.

If large pots are used, a minimum separation of approximately 50 mm (2") should be kept between the pot and peripheral inflammable materials. A minimum separation of some 50 mm (2") should be kept between the control dial or control panel and the pot or pan. The cooking pot must not touch

the control panel.

If pots or pans are removed temporarily, set the stovetop to the minimum setting. This will reduce the risk of suffering burns while working near open flames; in addition to saving gas, thus favoring the environment.

If there is a fault in the current supply, do not use the appliance.

If the appliance does not work properly, contact the technical service.

BURNER	Ø MINIMUM PAN SIZE			Ø MAXIMUM PAN SIZE
Large triple-flame burner (Center)			9”
Rapid burner (Left front)		9”		10”
(Right front)
Semi-rapid(Right rear)		6”		8”
Auxiliary (Left front)		5”		6”

9