Safety
If not used properly this product can be dangerous! This product can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this product. The operator is responsible for following the warning and safety instructions in this manual and on the product.
Explanation of Symbols on the product
Warning
Read the user instructions carefully to make sure you understand all the controls and what they do
Always keep the product on the ground when operating. Tilting or lifting the product may cause stones to be thrown out
Keep bystanders away. Do not operater whilst people especially children or pets are in the area
Switch off! Remove plug from mains before adjusting, cleaning or if cable is entangled or damaged. Keep the cable away from the blade.
Beware of severing toes or hands. Do not put hands or feet near a rotating blade.
Blade continues to rotate after the
machine is switched off. Wait until all machine components have completely
STOP stopped before touching them.
Do not use in the rain or leave the product outdoors while raining
Keep the cable supply away from the cutting means
General
1.Never allow children or people unfamiliar with these instructions to use the product. Local regulations may restrict the age of the operator.
2.Only use the product in the manner and for the functions described in these instructions.
3.Never operate the product when you are tired, ill or under the influence of alcohol, drugs or medicine.
4.The operator or user is responsible for accidents or hazards occurring to other
people or their property.
Electrical
1.The use of a Residual Current Device (R.C.D.) with a tripping current of not more than 30mA is recommended. Even with a R.C.D. installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Check your R.C.D. every time you use it.
2.Before use, examine cable for damage,
replace it if there are signs of damage or ageing.
3.Do not use the product if the electric cables are damaged or worn
4.Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one.
5.Your extension cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your mower.
6.Keep cable away from product, always work away from the power point mowing up and down, never in circles.
7.Do not pull cable around sharp objects.
8.Always switch off at the mains before disconnecting any plug, cable connector or extension cable.
9.Switch off, remove plug from mains and examine electric supply cable for damage or
ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Use only Flymo replacement cable. 10.Always wind cable carefully, avoiding kinking.
11.Never carry the product by the cable. 12.Never pull on the cable to disconnect any of the
plugs.
13.Use only on AC mains supply voltage shown on the product rating label.
14.Husqvarna products are double insulated to EN60335. Under no circumstances should an earth be connected to any part of the
product.
Cables
Use only 1.00mm2 size cable up to 40 metres length maximum.
Maximum rating:
1.00mm2 size cable 10 amps 250 volts AC
1.Mains cables and extensions are available from your local Approved Service Centre.
2.Only use extension cables specifically
designed for outdoor use.
Preparation
1.While using your product always wear substantial footwear and long trousers.
2.Make sure the lawn is clear of sticks, stones, bones, wire and debris; they could be thrown by the blade.
3.Before using the machine and after any impact, check for signs of wear or damage and repair as necessary.
4.Replace worn or damaged blades together
with their fixings in sets to preserve balance.
Use
1.Use the product only in daylight or good artificial light.
ENGLISH - 1