182 APPENDIX A: UPGRADING VCX SERVER SOFTWARE FROM V7.0 TO V7.1
Enable UPS monitoring? [N] :
If you do not have a UPS installed and enter n (or press Enter); the
remaining UPS configuration prompts are not displayed.
If you do have a UPS installed and enter y and see Configuring UPS
Monitoring for information on the subsequent UPS configuration
prompts.
5After completing the Adhoc Conferencing and UPS Monitoring prompts,
the server reboots. When the reboot process has been completed, the
system starts VCX 7.1.x services.
6After the system has completed the restart process, verify that the
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.1.xc). If the link does not point to the new version, wait a few
minutes and reenter the command. This could take several minutes and it
is important the link pointer is correct before proceeding.
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.1.xc
7Stop the Authentication and Directory service by entering the following
commands:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata stop
Upgrading the
Primary IP Messaging
Server
Follow the steps in this section to upgrade the primary IP Messaging
server.
1To start the upgrade process, enter these commands on the primary IP
Messaging server:
cd /opt/installtemp
tar xvf vcx-ipmsg-7.1.xc.tar
cd upgrade-7.1.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are: