228 APPENDIX B: UPGRADING VCX SERVER SOFTWARE FROM V7.1.X TO V7.1.Y
3After the system has completed the restart process, verify that the
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.1.yc). If the link does not point to the new version, wait a few
minutes and reenter the command. This could take several minutes and it
is important the link pointer is correct before proceeding.
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.1.yc
4Stop the Authentication and Directory service by entering the following
commands:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata stop
Upgrading the
Primary IP Messaging
Server
Follow the steps in this section to upgrade the primary IP Messaging
server.
1To start the upgrade process, enter these commands on the primary IP
Messaging server:
cd /opt/installtemp
tar xvf vcx-ipmsg-7.1.yc.tar
cd upgrade-7.1.yc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.1.yc is now available -------------------
2Switch to the new software version by entering the following command:
vcx-switchversion 7.1.yc
The system displays several status messages and then reboots. After the
the reboot process has been completed, the system starts VCX 7.1.y IP
Messaging services.
3After the system has completed the restart process, verify that the
upgrade has occurred by entering this command: