232 APPENDIX B: UPGRADING VCX SERVER SOFTWARE FROM V7.1.X TO V7.1.Y
secondary IP Telephony server. These messages are a
reminder—firewall setup was performed during VCX software
installation.
fThe Have you executed the ABOVE mentioned VCX-FIREWALL
steps? [y/n]: prompt appears.
Enter y to continue. The script executes.
When the replication is complete, Multi-Master Replication Status is
reported as NORMAL. Do not continue to the next step until the
replication is complete. Note that replication can take approximately
20 minutes to complete.
gYou can check the replication by entering the following command:
./checkReplication
3When the replication is complete, enter the following command to exit
the cworks account and return to the root account:
exit
4Start the Authentication and Directory service on the primary IP Telephony
server and the secondary IP Telephony server by entering the following
commands:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata start
5Start the Tomcat process on the primary IP Telephony server and the
secondary IP Telephony server by entering the following command:
./S70tomcat start
Upgrading a
Multi-Site System
With No Branch
Offices
Some VCX multi-site systems have regional offices but no branch offices.
Each regional office contains a primary VCX server and a secondary VCX
server. These servers perform call processing and IP Messaging tasks. One
of the regional offices also contains a Call Records server which gathers
call records from each of the regional offices.
■To upgrade the primary VCX server and the secondary VCX server,
follow the instructions in Upgrading a Single-Site System With Two
Servers earlier in this appendix.
■To upgrade the Call Records server, see the following section,
Upgrading the Call Records Server.