224 APPENDIX B: UPGRADING VCX SERVER SOFTWARE FROM V7.1.X TO V7.1.Y
Enter site ID configured for this system. For single-site systems, the site
ID is identical for both the primary VCX server and the secondary VCX
server.
bThe Enter the Number of MASTER SITEs other than the MASTER
DEFINITION SITE [1]: prompt appears.
Press Enter to accept the default.
cThe Enter the MASTER DEFINITION SITE IP Address [IP
address] prompt appears.
Enter the IP address of the Master Definition site or press Enter if the
displayed address is correct. This is typically the IP address of eth0 on
the primary VCX server.
dThe Enter the MASTER SITE 1 IP Address [0.0.0.0] prompt
appears.
Enter the IP address of the Master Site. This is typically the IP address
of eth0 on the secondary VCX server.
eThe Do you want to continue with the above settings? [n/y]:
prompt appears.
Enter y to continue. The script executes.
During script execution, messages appear describing the replication
setup. Messages also appear stating that firewall setup should allow
communication between the primary VCX server and the secondary
VCX server. These messages are a reminder—firewall setup was
performed during VCX software installation.
fThe Have you executed the ABOVE mentioned VCX-FIREWALL
steps? [y/n]: prompt appears.
Enter y to continue. The script executes.
When the replication is complete, Multi-Master Replication Status is
reported as NORMAL. Do not continue to the next step until the
replication is complete. Note that replication can take approximately
20 minutes to complete.
gYou can check the replication by entering the following command:
./checkReplication
3When the replication is complete and status is reported as NORMAL,
enter the following command to exit the cworks account and return to
the root account:
exit