Upgrading a Multi-Site System With No Branch Offices 273
6Start IP Messaging on the primary IP Messaging server by entering the
following command:
./S60ums start
Run the admincfg script on both the primary VCX server and the
secondary VCX server. See Post-Upgrade Requirements.
Upgrading a
Multi-Site System
With No Branch
Offices
Some VCX multi-site systems have regional offices but no branch offices.
Each regional office contains a primary VCX server and a secondary VCX
server. These servers perform call processing and IP Messaging tasks. One
of the regional offices also contains a Call Records server which gathers
call records from each of the regional offices.
■To upgrade the primary VCX server and the secondary VCX server,
follow the instructions in Upgrading a Single-Site System With Two
Servers earlier in this appendix.
■To upgrade the Call Records server, see the following section,
Upgrading the Call Records Server.
All upgrade commands are executed locally at the console.
Upgrading the Call
Records Server
To upgrade the Call Records server:
1Log in to the Call Records server as root.
2Stop all VCX processes on the Call Records server by entering the
following commands:
cd /etc/init.d
./vcx stop
3Obtain a copy of the vcx-bss-7.0.xc.tar software upgrade file and
place it in the /opt/installtemp directory on the Call Records server.
4Enter these commands:
cd /opt/installtemp
tar xvf vcx-bss-7.0.xc.tar
cd upgrade-7.0.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.