Upgrading a Single-Site System With Four Servers 269
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.0.xc
7Stop IP Messaging. When the primary IP Messaging reboots, IP
Messaging restarts and must be stopped before you can upgrade the
secondary IP Messaging server. However, you should ensure IP Messaging
is fully active before stopping it. To check IP Messaging status, enter the
following commands:
su - app
cd /opt/3com/VCX/UMS/vcx-scripts/init.d
./vcxums status
8If the returned status is ...running..., stop IP Messaging by entering
the following commands:
exit
cd /opt/3com/VCX/scripts/rc3.d
./S60ums stop
Upgrading the
Secondary IP
Telephony Server
Follow the steps in this section to upgrade the secondary IP Telephony
server.
1To start the upgrade process, enter these commands on the secondary IP
Telephony server:
cd /opt/installtemp
tar xvf vcx-softswitch-7.0.xc.tar
cd upgrade-7.0.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.0.xc is now available -------------------
2Obtain a license key for the server. See Obtaining a LicenseKey File.
3Install the license key. See Installing a LicenseKey File.
4Switch to the new software version by entering the following command:
vcx-switchversion 7.0.xc