184 APPENDIX A: UPGRADING VCX SERVER SOFTWARE FROM V7.0 TO V7.1
feature's operation. Typically the Central Servers are at
one of the regional sites.
Is this a Central Server for Global Voicemail? [N] :
If this server has been configured as a Global Voicemail Central Server,
enter y and go to step 5.
If you answer n to indicate that this is not a Central Server, you will be
prompted to enter the Central Server IP address.
5After completing the UPS Monitoring and Global Voicemail Integration
prompts, the server reboots. When the reboot process has been
completed, the system starts VCX 7.1.x services.
6After the system has completed the restart process, verify that the
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.1.xc). If the link does not point to the new version, wait a few
minutes and reenter the command. This could take several minutes and it
is important the link pointer is correct before proceeding.
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.1.xc
Upgrading the
Secondary IP
Telephony Server
Follow the steps in this section to upgrade the secondary IP Telephony
server.
1To start the upgrade process, enter these commands on the secondary IP
Telephony server:
cd /opt/installtemp
tar xvf vcx-softswitch-7.1.xc.tar
cd upgrade-7.1.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.1.xc is now available -------------------